Replacing Fabtotum Hybrid Head v1 Hotend with E3D Lite6
I replaced the stock hotend of the Fabtotum Personal Fabricator Hybrid Head v1 by an E3D Lite6 hotend (The full metal V6 should work the same way). In this post I describe the steps to remove the old hotend, get in the new hotend and the simple modifications to the firmware that were required.
Continue reading “Replacing Fabtotum Hybrid Head v1 Hotend with E3D Lite6”
Case for MP1584 Based Step-Down Converter Board with USB Port
This post is to share my self-made 3D printed housing for a 5V USB voltage converter. Since the used converter board is quite common, I guess others may profit from this design.
Continue reading “Case for MP1584 Based Step-Down Converter Board with USB Port”
Interfacing EasyMeter Q3M via Info-Interface
The installation of my fuel cell heating required a bi-directional power meter. Bonn Netz, my local power network provider, uses meters of type EasyMeter Q3M which have two infrared interfaces: A bidirectional D0 interface, and a read-only info interface. I use the info interface (INFO-DSS) to read out power consumption and production of the three phases. For this, I built an optical interface, a 3D printed housing for it, and use the UART of a Raspberry Pi with python to get the values.
Continue reading “Interfacing EasyMeter Q3M via Info-Interface”